Water & Diesel Plumbing Fittings in Perth

John Guest 12 mm push-fit is the plumbing standard for every touring canopy and camper trailer we build. Push the tube in until it seats, done — no glue, no threads, no leaks. WRAS-approved for potable water, rated to 10 bar / 60°C. We stock the elbows, tees, crosses, check valves, bulkhead adapters and stem adapters (BSP male and female) to build any water circuit from tank to tap.

The Egon Water-Hub Hose Kit is the plug-and-play canopy water manifold — a pre-plumbed 12 mm push-fit block that takes tank in, hot and cold out to sink and shower, all off one bracket. Our own Plumbing Fitting Kit for Hot & Cold Water Systems bundles the fittings, brass thermostatic mixing valve (1/2" BSP female) and shower hose you need to plumb a diesel-fired hot water setup safely.

The Diesel Heat Pro Quip DIY Fuel Tank Kit with plastic quick-disconnect lets you run a diesel air heater off a jerry can without hard-plumbing into the main tank — Nitto-compatible fittings on both ends. For permanent installs, the Boab Filler Kit gives you a lockable fuel filler for auxiliary diesel or water tanks, same fitting quality as the Boab tanks themselves.

MAKO Black Vinyl Tube (BVT010) is reinforced hose rated for pressurised water — not the clear irrigation hose from Bunnings that splits at the bulkhead in twelve months. Match it with proper worm-drive stainless hose clamps or Oetiker O-clips at every barb. Barb fittings are 12 mm brass or plastic — brass for anything under vibration.

Every canopy build that leaves 1/6 Radius Loop, Bayswater with hot and cold water is plumbed with John Guest 12 mm, an Egon Water-Hub manifold, a brass thermostatic mixing valve on the shower feed (so nobody gets scalded), and pressure-tested to 10 bar before it goes home. Bring the canopy in and we'll plumb the lot.