LED Work, Rock & Utility Lights in Perth

Scene beam floods a wide, close working area — camp kitchen, canopy setup, jobsite. Spot beam throws a narrow column further out — unloading a trailer at 20 metres, checking the fence line. Combo splits the LEDs so you get both patterns from one housing. The Altiq DX4 and CX4 both come in all three; the Lightforce ROK9 is available as White (spot-biased) or Utility (flood).

The Altiq CX2 Flush Mount hides completely in a canopy panel with no external bracket. The DX4 and CX4 are the higher-output units for tray lighting and canopy exteriors. Blackout, Amber and Arctic Edition covers let you match the light to the build — amber cuts through dust better than white, blackout keeps a stealth look when the light's off.

Lightforce is Australian-made, IP69K rated, and warrantied through the local network. The ROK9 White is the single-unit workshop favourite; add the 30° Angled Base to aim it down over a tray. The Rok 20W and 40W Ultra Flood use Cree LEDs at 20–30V — well suited to 24V trucks, mine-spec vehicles and dual-battery canopies.

Rock lights sit inside the wheel arch or under the chassis and light up the ground beside the vehicle — essential when you're picking a line in low-range at night. The Altiq Spectrum Pro RGB-W kit does white plus full colour so the same lights work as chassis lighting or as show/camp mood lighting. Flat Mount and RackLok RhinoRack Backbone brackets are stocked to suit.

Work lights are only useful if they're wired properly — fused, switched through the correct relay, and connected so they don't back-feed the battery. Our Bayswater workshop wires every light we sell into your existing switch panel or a new Redarc TVMS / Garmin PowerSwitch loom. Book in at 1/6 Radius Loop, Bayswater WA 6053.